About installing the wire clutch perch kit
The information is based on theoretical values.
It does not guarantee a reliable installation in the vehicle.
For actual feeling and wearing not absolutely correct because this product is universal product

Confirm stock wire
Pulling waire from handle side

Available for
①Tam size is φ8
②Wire end size is φ8
③Inner wire scale is between 40-50mm
If it is not applicable, change the tension on the engine side.
It can't be fit. if the above dimensions are not met even if the engine tension is changed.

 

Choice the ratio
Confirm the distance for between center of pivot to wire tam.
Available from 28mm to 32mm

Our recommend to use same size as stock
（ It reduces the friction, so it is easy to be control at the same distance ）

Confirm to switch
（ It reduces the friction, so it is easy to be control at the same distance ）

< 2 line type >
Same as picture ⇒Don't need to processing
Different as picture ⇒Need to processing
< 3 line type >
⇒2 line from motocycle conect to terminal
(Should be hold clutch lever when you start engine)
< 4 line type >
⇒Unavailable

Confirm the clearance

That product is universal type so this have possibility toch to cowl, meter, some parts

< Wire clutch perch kit >

< Elaborate Wire clutch perch kit >